Yu_Villa Renderings LoRA for Stable Diffusion 1.5

Usage Recommendations

1. When using, you can appropriately increase the CFG value; 5-12 is a reasonable range.

2. Choose Euler a as the sampling method, 30 steps can achieve relatively fast speed; if you need to improve quality, you can choose DPM++ 3M Karras and set the sampling steps to around 45.

3. The resolution of generated images should not be lower than 1024x1024, otherwise quality degradation may occur.

4. It is recommended to use this with the 1.5 version base model I released for the best results.

5. The trigger prompt word is "villa".

6. The recommended weight is 0.7 or higher, and can be set to 1.

使用建议

1.使用时可以适当拉高CFG值，5-12都是合理范围。

2.采样方法选择euler a，30步即可达到较快的速度；如需提高质量，可选择dpm++3m karras，并设置45左右的采样步数。

3.生成图片分辨率尽量不要低于1024x1024，否则可能会出现质量下降的情况。

4.建议搭配我发布的1.5版本大模型使用效果最佳

5.触发提示词为villa

6.权重建议为0.7以上，可以设为1