Hunyuan3D 2.x Hybrid Workflow

A hybrid workflow for ComfyUI. Uses Hunyuan3D 2.0 MV for mesh generation,and Hunyuan3D 2.1 for better texture generation. The workflow is slower than full 2.0, but faster than a full 2.1. I'm using a 4060 8gb and 16gb ram,and it works without oom errors.I culled some of the unneeded nodes, but you still will need kijai's ComfyUI-Hunyuan3DWrapper and visualbruno's ComfyUI-Hunyuan3d-2-1

You may need to install the wheel to match your system(3.10, 3.11, or 3.12 only) in the 2.1 hy3dpaint\DifferentiableRenderer\dist folder to get inpaint working.

V2 is basically the same,just changed the texture res to 512 from 1024 for faster texturing. Also added ComfyUI-pause to let you decide if mesh is ok, before texturing. Should save some time especially on lower end PCs,without waiting on texture gen.

If I find a better or faster way,I'll upload a new version.